Change Your Own Scooter Oil And Save Your Scooter Repair Money

In Chinese scooters it is vital to change the oil forOnce you put off the cap or the bolt, you can allow
ensuring a proper functioning. Most of the riders ignorethe container to drop while the spring and oil screen
this important part and therefore the scooter mayalso come off. It will allow the container to fall and
breakdown in the middle because the engine getsonce the oil starts draining you can remove the bolt,
burned out. While changing oil there is no need tospring and the oil screen and then clean them off.
spend a dime on the mechanic. Therefore, why youTherefore, rinse the oil with dry hands.
should spend money when you can change the oilYou can inspect the oil to see that if it turns milky. This
yourself?also means that there is water leaking in the other
So before proceeding with the oil changing process itparts of your Chinese scooter and therefore it should
is important that you should arrange for everythingbe taken to the mechanic for reselling the gearbox.
what you need. One of the most important thingsOtherwise, you can also replace the oil screen, the
required is adjusting the socket set which is alsospring and the bolt as well to the bottom of the
known as adjustable wrench. Then you also requiredscooter.
an oil collection pan or a mini container that has a wideHowever, there is a caution that you need to follow on
mouth. These are some of the essential item foradding the oil and so there must be one repair shop
changing the oil even when you use a cheap scooter.but too much of adding oil is not commendable.
Then, consider the most obvious thing i.e. the oil.When you start adding oil in your Chinese scooter then
The oil for the Chinese scooters can be anythingyou can pour some oil and let the oil drain in to the
except the 30 weight. You can either use 10/40, 15/50bottom of the tank that can happen within 15 seconds.
or with any combination of the 10-15 or with 40-50Once you are done with that, you need to measure
weight but don't ever use 30 weight.the oil with dip stick and there is no need to get
To begin the process of oil change in the scooter, it isscrewed in it. You can simply stick it as far as possible
necessary to put the scooter on the back stands soback into the oil sprout and pull it out. Once the oil is at
that it remains on a balanced level. You can even looka level then you can add some more oil. After doing
out for a large bolt under the scooter or below thethat it is advisable to start your scooter and let it run
engine. After when you remove the large bolt underfor about 1-2 minutes and then shut it off. Once you
the scooter or below the engine, you can remove thestart again your Chinese scooter will run like a chariot!
large bolt and place a container to catch the oil.